CARE AND MAINTENANCE

TANK

• Keep moisture out and retain some pressure within the cylinder.
• Extended storage: remove accessories and rinse tank with fresh water.
• Secure cylinder vertically in a cool dry place and reduce pressure to 20-100 psig.
• Handling: use care to secure when transporting cylinders. if dropped, check for dents.
• Valve care: keep clean and check for dents, dings, or bent parts.
• Boots and backpack: remove boot, cover and backpack frequently to clean away salt deposit and inspect for any corrosion.
• Have your cylinder inspected annually and hydro every five years.

REGULATOR

Cleaning is the most important maintenance procedure you can perform. Rinse in fresh water as soon as possible after diving. Use warm water to rinse or soak as this will dissolve any dried salt crystals. You can immerse the entire assembly in warm water. Always insure that the water tight dust cap is securely in place. Soak regulator about 10-20 minutes, sloshing it around to loosen any stubborn particles. Never push purge button while completely immersed under-water. After soaking, attach regulator to a pressurized air tank and purge the 2nd stage. This will blow out any unwanted particles, (this is a must on some regulators).

HOSES

When rinsing-- slide the hose protectors down. This will reduce corrosion. Always replace any hose that is frayed, cut, or badly chafed. Use hose protectors to protect areas near 1st. Stage (is subject to stress). Sharp bends, kinks, and tight loops can weaken and damage the hoses, regulators should be overhauled yearly, this is a must for all regulators under warranty.

BUOYANCY COMPENSATOR (B.C.D.)

Always wash B.C.D. after each dive, especially if diving in fresh or chlorinated water. Wash inside and out, direct a stream of water into the mouthpiece or oral inflator valve. Only use cold water. Shake and drain out the water. You can use mouth wash inside to kill bacteria. Store clean and dry partially inflated.